REMEHA Quinta Ace 160, Installation, User And Service Manual

Page: 45 / 80

Tab.31 Checking/setting values for O
2
/CO
2
at part load for G30/G31
(butane/propane)
Values at part load for G30/G31 (bu­
tane/propane)
O
2
(%) CO
2
(%)
Quinta Ace 160 5.4
(1)
- 5.7 10.0 - 10.2
(1)
(1) Nominal value
Caution
The O
2
values at part load must be higher than the O
2
values at
full load.
The CO
2
values at part load must be lower than the CO
2
values
at full load.
3. If the measured value is outside of the values given in the table,
correct the gas/air ratio.
4. Using the adjusting screw B, set the percentage of O
2
/CO
2
for the gas
type being used to the nominal value. This should always be within
the maximum and the minimum setting limits.
7.7 Final instructions
1. Remove the measuring equipment.
2. Screw the cap on to the flue gas measuring point.
3. Seal the gas valve unit.
4. Put the front casing back.
5. Heat the central heating system up to approximately 70°C.
6. Switch the boiler off.
7. Vent the central heating system after approx. 10 minutes.
8. Turn on the boiler.
9. Check the water pressure. If necessary, top up the central heating
system.
10. Fill in the following data on the sticker included, and attach it next to
the data plate on the appliance.
If adapted to another gas, fill in the gas type;
The gas supply pressure;
If set to overpressure application, fill in the type;
The parameters modified for the changes mentioned above.
11. Instruct the user in the operation of the system, boiler and controller.
12. Inform the user of the maintenance to be performed.
13. Hand over all manuals to the user.
14. Confirm the commissioning with a signature and a company stamp.
The boiler is now ready for operation.
Fig.49 Position of adjusting screw B
AD-0000140-02
2
1
B
Fig.50 Example filled-in sticker
AD-3001124-01
Adjusted for
/ Réglée pour /
Ingesteld op / Eingestellt auf
/ Regolato per / Ajustado
para / Ρυθμισμένο για /
Nastawiony na / настроен
для / Reglat pentru /
настроен за / ayarlanmıştır /
Nastavljen za / beállítva/
Nastaveno pro / Asetettu
kaasulle / Justert for/
indstillet til/ ضبط ل :
C
(10)3(X)
Gas
C
(12)3(X)
mbar
Parameters
/ Paramètres /
Parameter / Parametri /
Parámetros / Παράμετροι /
Parametry / Параметры /
Parametrii / Параметри /
Parametreler / Paraméterek
/ Parametrit / Parametere /
Parametre / المعلمات :
G20
20
DP003 - 3300
GP007 - 3300
GP008 - 2150
GP009 -
7 Commissioning
7625116 - v.06 - 17102018 45