38
Regency HZ33CE Gas Fireplace
INSTALLATION
INSTALLING THE OPTIONAL FAN (PRIOR TO UNIT INSTALLATION)
4.
Connect fan ground cable to ground lug. Refer to wiring diagram.
5.
Slide the thermodisc/cover assembly into the bracket clip on the underside of
the fi rebox (Diagram 4 ).
Check that no wires will touch hot surfaces.
Diagram 5
Diagram 6
Fan Control Box
Lower Base
Cover
Bottom Panel
Control Mounting Plate
Diagram 7
Diagram 1
Diagram 8
9.
Secure the fan wires and power cord by attaching one of the ad-
hesive backed wire holder clips (Part #910-199. onto the Fireplace
base. Use the second clip to bundle up the wires approximately 4"
from the control box. Ensure that there is no interference with the
wires when the faceplate and trim are installed and that no wires
will touch the hot metal surfaces or sharp edges.
10.
Plug the fan power cord into the rear end of the receptacle box to
provide the maximum clearance.
11. Reverse Steps 1 and 2.
TO REMOVE THE FAN
1.
Shut the power off.
2.
Follow Steps 2 - 7 of `Installing the optional fan after unit is installed`.
3.
Reverse Step 8 of `Installing the optional fan after unit is installed`.
Note: The bearings are lubricated for life. Do not lubricate them.
Make sure you vacuum the fan area on a regular basis.
IMPORTANT:
These fans collect a lot of dust from within your home. Ensure you
maintain these fan motors on a regular basis by vacuuming out
the fan blades and housing using a soft brush nozzle.
7.
Position the control plate assembly on the left hand side of the
fi rebox. Diagram 7
8.
Secure the control plate assembly with 1 screw as shown in Diagram
8.
120 Volt AC power is needed for the fan switch and blower. The fan can be hard wired
if desired. The grounded duplex receptacle should be installed into the supplied
receptacle box by a qualifi ed electrician. The neutral (wider) slot of the polarized
receptacle should be at the top.
Unit must be grounded at all times. Do not cut the ground terminal off under
any circumstances.
An optional fan can been installed
prior to unit installation
by following these steps.
1.
Remove lower base cover by tilting forward and lifting out each side to release.
(Diagram 1).
2. Loosen four (4)screws (two on each side) inside of the bottom panel of the clean
front, slide panel out.
3.
Turn the fan base on its side (with the base facing towards you) and then slide
the fan in towards the rear of the unit. Turn the fan upright and slip it over the
two mounting studs. Take care not to damage the insulation on the fan base.
Ensure that the fan blades do not rub against the valve tubing.
6.
Attach the fan control box to the Control Plate. (Diagrams 5 & 6.
Diagram 2
Diagram 3
Diagram 4