RC500EX
|
19
owner's information
First Fire
The first fire in your stove is part of the paint curing
process. To ensure that the paint is properly cured,
it is recommended that you burn your fireplace
for at least four (4) hours the first time you use
it with the fan on. When first operated, the unit
will release an odour caused by the curing of the
paint, the burning off of any oils remaining from
manufacturing. Smoke detectors in the house may
go off at this time. Open a few windows to ventilate
the room for a couple of hours.
The glass panel may require cleaning after the unit
has cooled down.
DO NOT ATTEMPT TO CLEAN THE
GLASS WHILE IT IS HOT.
Note: When the glass is cold and the
appliance is lit, it may cause
condensation and fog the glass.
This condensation is normal and
will disappear in a few minutes
as the glass heats up.
Operating Instructions
1.
Read and understand these instructions before
operating this appliance.
2.
Check to see that all wiring is correct and
enclosed to prevent possible shock.
3.
Check to ensure there are no gas leaks.
4.
Make sure the glass in the door frame is properly
positioned. Never operate the appliance with
the glass removed.
5.
Verify that the venting and cap are unobstructed.
6.
Verify log placement. If the pilot cannot be
seen when lighting the unit, the logs have
been incorrectly positioned.
7.
The unit should never be turned off, and on
again without a minimum of a 60 second wait.
NOTE:
This appliance will operate with 4 AA back-up
batteries installed (see Back-up Battery section
for details) during power outages. Only the
fan and light will not operate until power is
During the first few fires, a white film
may develop on the glass front as part
of the curing process. The glass should
be cleaned
or the film will bake on and
become very difficult to remove. Use a
non-abrasive cleaner and NEVER clean
the glass while it is hot.
DO NOT BURN THE APPLIANCE
WITHOUT THE GLASS FRONT IN
PLACE.
restored. If the remote is misplaced, the unit
can be shut off by flipping the main
ON/OFF
switch, located behind the front cover plate, to
the
OFF
position.
IMPORTANT:
The remote control system supplied
with this appliance has several options for
starting/operating the appliance, please read the
remote control operating instructions (packed
with remote control) to understand how to
operate this remote system.
Backup Battery
In the event of a power outage the unit may be
operated by a back up battery system.
1. Open lower door of unit.
2. Remove lower access panel (see section ''Lower
Access Panel Removal/Installation'').
3. Install 4 AA batteries into battery pack.
4. Attach battery pack to left wall on unit, ON/OFF
switch with velcro.
- The remote or remote override toggle switch can
now be used to turn the unit ON/OFF.
- With the battery back up, the fan and lights will
not function.
- To prevent corrosion, it is recommended that the
back up batteries be removed once power is
restored.
Battery Pack
Summary of Contents for Contura RC500EX
