LRI4E / HRI4E Direct Vent Gas Insert
|
25
|
25
installation
1
3
2
4
HRI4E Pin Landing
HRI6E Pin Landing
1
4
5
6
. Place Log 4, match pin locator on Log 4 with landing pin on Log 1.
Angle the longest point on Log 4 is approximately 1/4' from the out-
side edge of the burner tray.
7
. Place Log 5 across Log 4,match pin locator on Log 5 with landing
pin on Log 4.
Note:
there are 2 pin locators on Log 5, lower locator is for HRI4E units
and the upper locator is for the HRI6E units.
1
2
3
5
. Place Log 3, rest on Log 2, match pin locator on Log 3 with landing
pin on Log 1. Angle the longest point on Log 3 is approximately 1/4'
from the outside edge of the burner tray.
Line up pin locator and pin, Logs 1,3
Line up pin locator and pin, Logs 1,4
Line up pin locator and pin, Logs 5,4
1
2
9-1/4"
1
2
3
. Place Log 1 on Rear Log Bracket in front of tabs, ensure Log is cen-
tered. Place small amount of glass crystals on pilot cover, over top
pilot area in front of Log 1.
4
. Place Log 2 on the glass, angled with the non charred point of the Log
is approximately 9-1/4" from the right side of the burner tray.
Center Log 1 on bracket
Position Log 2
Summary of Contents for Liberty LRI4E-LP
