LRI4E / HRI4E Direct Vent Gas Insert
|
33
|
33
installation
tooltip
1. Pop out tab on right side (facing front) of outer faceplate and place
grommet in opening to route power cord.
2. Install the outer faceplate and secure with 5 screws for the L/HRI4E
and L/HRI6E as shown.
Note: 4 corner screws can be installed on the unit loosely as the hole
on the outer faceplate are keyholes.
Route power cord on right side between the inner and outer proile of
faceplate. Use a grommet and wire clip to secure.
3. Install the Vignette faceplate by hooking the lange over the hanger
as shown.
Final Install
Note:
Shown with Optional Hearth Trim
4. Ensure inger prints or smudges are removed from the faceplate
before the irst iring.
NOTE:
Pull the bottom of the Vignette faceplate towards you to access
the remote receiver.
Power Cord
Location
Pop out tab on right side
of outer faceplate
Black Chrome Handling Instructions
*
All hand and inger marks
MUST
be cleaned off with a soft cloth. Use an ammonia based cleaner (ie. glass cleaner) to remove any
inger prints before applying heat to the unit. Use supplied gloves when installing Black Chrome Faceplates.
Failure to do this will result in burn stains on panels which you will be unable to remove.
Not protected by product warranty.
tooltip
VIGNETTE FACEPLATE WITH SAFETY SCREEN INSTALLATION
Summary of Contents for Liberty LRI4E-LP
