Regency Fireplace Products Liberty LRI4E-LP, Owners & Installation Manual

Page: 44 / 64

44 |
LRI4E / HRI4E Direct Vent Gas Insert
|
44
operating instructions
IMPORTANT: The remote control system supplied with this appliance has
several options for starting/operating the appliance using the power button
and ON/OFF key on the hand held transmitter.
Prior to operating this appliance, please read the remote control operating
instructions (packaged with remote control) to understand how to operate
this remote control system. Option to download remote functions video
with QR code below.
1. Ensure the wall switch/receiver is in the remote position. (see Diagram 1).
3. After approximately 4 seconds the spark ignition system will spark for 60
seconds to light the main burner.
4. The unit will turn on.
Note: The irst try for ignition will last approximately 60 seconds. If there is no
lame ignition (rectiication) the board will stop sparking for approximately
35 seconds. After wait time, the board will start second try for ignition by
sparking for approximately 60 seconds. If there is still no positive ignition
the board will go into lock out.
The system will need to be reset as follows:
a) Turn the system off using ON/OFF switch or press ON/OFF button - if
using optional remote.
b) After approximately 2 seconds turn on ON/OFF switch or press ON/OFF
button if using optional remote.
c) Repeat step 2.
ON/OFF
Button
Diagram 1
Diagram 2
Set Switch to
Remote
SHUTDOWN PROCEDURE
1) Turn the wall mounted switch or remote to the "OFF" position.
2) If service is to be performed – you must disconnect power and shut off
gas to the unit.
Remote shown in Manual Mode on Hi
Prolame
video
2. Press and release the ON/OFF button on the remote handheld transmit-
ter (see Diagram 2). An audible beep should be heard from the receiver.
LIGHTING PROCEDURE