Regency Fireplace Products Cascades I2500, Owners & Installation Manual

Page: 14 / 40

14
|
Regency I2500M
|
14
installation
Diagram 4
11. Install the unit by first setting the rear of the
unit into the fireplace. See Diagram 4. Ensure
that the unit is centered in the existing fireplace
and lined up with the flue adaptor.
12. Slide the unit back until the flue adaptor is slightly
engaged. At this point it is recommended to level
the unit. This will keep the adaptor from binding.
Pull Rod
Diagram 5
13. Insert the provided pull rod through the hole in
the top center of the unit. Secure the threaded
end into the flue adaptor as shown in diagram
5. While sliding the unit into place pull on the
rod to ensure that the flue adaptor is properly
engaged. See Diagram 6. Double check the
adaptor is seated properly and the pull rod in
the firebox, locate the two holes lined up to the
two holes on the adaptor.
14. To complete the install, use the two bolts,
washers and lock washers removed in step 6
and install them, tighten down using the 1/2"
socket to ensure the adapter is positively se-
cured to the unit. Once completed remove pull
rod and place away for future re-install.
Pull Rod in place
Diagram 6
Diagram 7
10. Fully insert the probe into the probe bracket as
shown. See diagram 3.
Diagram 2A
Probe Bracket
Cutout in
adaptor properly
aligned to probe
bracket
Diagram 3
15. When re-installing flue collar after it has been
attached to the flex, be careful to guide the
bypass arm through front above the door. This
can only be guided through firebox opening.
Bypass rod
Opening
for bypass rod
Guide the bypass
rod through opening
inside firebox
Diagram 8
16. Repeat steps 5-1 to complete install.