Regency
®
CLASSIC™ C34-11 Direct Vent Freestanding Gas Stove
| 47
|
47
maintenance
REMOVING VALVE
ASSEMBLY
1.
Shut off gas and electrical supply.
2.
If optional fan is installed, disconnect power
source to stove.
3.
Remove access panel.
a)
Front panel on pedestal model.
See Diagram 1.
b)
Panel from bottom of leg shield.
See Diagram 2.
Note: Access panel only has to be loosened
to be taken out.
4. Remove valve cover plate by removing two (2)
screws.
5. Disconnect receiver wire.
6. Remove cover plate by removing 4 screws
(Pedestal option only).
7. Disconnect gas line to stove.
Diagram 2
Diagram 1
Access Panel
Cover Plate
Valve Cover
Plate
8. Disconnect 3/8" NPT pipe from 90
o
elbow on
valve.
9. Disconnect the two (2) switch wires from valve.
10. Disconnect three (3) fan wire from DC sparker.
11. Remove orifice.
12. Loosen four (4) Phillips head M5 valve mounting
screws from underside of firebox. Drop valve
assembly down.
To remove valve from valve assembly, con
-
tinue.
13. Remove two (2) thermopile wires.
14. Remove thermocouple with a 9 mm (metric)
wrench.
15. Remove pilot nut with an 11 mm wrench.
16. Remove valve to orifice nut with a 13/16"
wrench.
17. Remove inlet pipe with pipe wrench. Note
orientation of 90o elbow.
18. Remove two (2) phillips head M5 screws on
each side of the valve.
19. Remove valve and remove gas out 90o brass
fitting. Note orientation of fitting.
See Diagram in "Optional Fan Installation"
section for more detail.
INSTALLING
VALVE ASSEMBLY
1. To install a new valve assembly, reverse instruc-
tions for
removing valve
. See assembly steps
1-10.
2. Check for leaks and manifold pressure. See
Gas Pressure Test
instructions.
3. To reinstall valve, reverse instructions for re-
moving valve assembly, steps 11-17.
GLASS GASKET
If the glass gasket requires replacement use (Part
# 936-240). this gasket is sold per foot with 4
feet required.
GLASS
REPLACEMENT
Your CLASSIC stove is supplied with high tem-
perature, 5 mm Neoceram ceramic glass that
will withstand the highest heat that your unit will
produce. In the event that you break your glass
by impact, purchase your replacement glass from
an authorized Regency
®
dealer only.
If the front glass requires replacement, use part
# 490-548.