40
|
Regency
®
CLASSIC™ C34-11 Direct Vent Freestanding Gas Stove
|
40
installation
Diagram 5
Diagram 2
Note: If the flame hesitates at any point,
check the area of hesitation and see
if there is an ember or rock wool
blocking a burner port or ports. If
so, move the obstruction and then
check the flame flow again.
10. Replace the glass. Secure door in the closed
position using the door securing bracket and
the screw provided, Figure 1. See door and
glass frame instructions.
Note: Door securing bracket is there for
safety
.
DOOR AND GLASS FRAME
1. The glass frame fastens with four screws.
See Diagram 1.
Door
Screws
Diagram 4
Diagram 3
Door
Screws
Diagram 1
Note: The door must be kept closed at all
times, except during maintenance. The
unit must never be operated without
the glass in the door, or with the door
open.
2. Remove the glass frame from the stove by
removing four hex nuts (support glass so it
doesn't fall out). See Diagram 1.
3. Ensure that the front and rear deflectors are
installed.
4. Remove the logs from the box and carefully
unwrap them.
The logs are fragile, handle
with care. Do not force into position.
5. Place the rear log on the rear log support pins
in the back of the unit. The flat side of the log
facing the back of the unit. Carefully push the
log down onto the pins. See Diagram 3.
LOG INSTALLATION
WARNING: Dangerous operating con
-
ditions may occur if these logs are not
positioned in their approved locations.
Read the instructions below carefully
and refer to the Diagrams. If logs are
broken do not use the unit until they are
replaced. Broken logs can interfere with
the pilot and burner operation.
The gas log kit contains the following:
a) Front Log
b) Rear Log
c) Small Cross Logs (2.
d) Bag of embers
e) Bag of rockwool
f) Bag of platinum embers & Embaglow
(supplied with packaged manual)
1. Remove securing screw from bracket as shown.
DO NOT TRY TO TURN THE
DOOR HANDLE! IT IS NOT
DESIGNED TO BE MOVED.
6. Place the front log in the front of the unit, align-
ing the holes on the underside of the log with
the log support pins in the front of the unit.
Carefully push the log down onto the pins. See
Diagram 3.
7. Place the cross logs on top of the larger logs
aligning the holes on the underside of the cross
log with the log pins in the larger logs. See
Diagrams 3 & 4. Carefully push the cross logs
onto the pins.
8. Distribute the embers along the mesh ember
tray but do not cover the burner ports. (Burner
ports are the little holes on the top of the burner
tube.) Pull off ember size pieces from the rock
wool. Gently place the pieces on top of the
embers. See Diagram 5.
Do not put the rock wool directly on the burner.
Before putting the glass back on, turn the unit
on as per lighting instructions in this manual.
Watch the flame to see if it flows smoothly
around from one end to the other. (Use Extreme
Caution and ensure proper light off of burner.)
Note: The unit must never be operated with
-
out the glass in place. (One exception
is made during the log and ember
installation.)
2. The securing bracket keeps the door closed.
9. Separate platinum embers and place on the mesh
ember tray alongside embers. Avoid stacking
platinum embers. The Embaglow embers may
be put on top of the platinum embers as desired.
Note: Do not put any type of embers on the
rear burner. This can only be installed on the
front portion of the burner.
Diagram 1
Door
Screws
Hex Nuts
Hex Nuts
