Reflex Marine FROG-9, User Manual

Page: 60 / 64

User Manual FROG-9
Rev 05 Page60
12 APPENDIX D – FROG-9 MARKINGS
12.1
Essential Marking Requirements
The FROG-9 should be indelibly marked with the following
information:
i. Description of Equipment.
ii. Model.
iii. Serial Number.
iv. Manufacturer ’ s Address.
v. Year of Construction.
vi. Mass of Usual Configuration / Mass without Payload
(Tare weight).
vii. Safe Working Load (SWL).
viii. Maximum Gross Mass (MGM).
ix. Maximum Number of Passengers.
Fig 8: FROG-9 Marking Plate
Decal - Vinyl Stickers on Front Edge of Seats
Note: MDPE buoyancy requires preparation of surface for good contact adhesion. Gently heat the contact area until the
surface is oxidised and appears shiny.
Refer to diagram FROG-9 Seat Marking Plan for layout:
i. Front edge of seat base: 3 off per FROG- 9. “No Step” .
ii. Top of centre seat backs: 3 off per FROG- 9. “Ensure belts are properly tightened and
adjusted before lift- off” .
iii. Top of all seat backs: 9 off per FROG- 9 “No Hand Hold” .
iv. Top of all seat backs: Seat numbers to be placed according to loading plan in Section 5.6 .
Decal - Vinyl Stickers Located on Outside of Buoyancy Units
Note: MDPE Buoyancy requires preparation of surface for good contact adhesion. Gently heat the contact area until the
surface is oxidised and appears shiny.
Refer to diagram FROG-9 Column Marking Plan for layout:
i. 3 off per FROG-9 Circular FROG Logo - 250 mm dia.
ii. 3 off per FROG-9 Rectangle Reflex Marine Ltd Logo – 250 x 125 mm.
iii. 2 off per FROG- 9 Rectangle Reflex Marine Ltd URL “ www.reflexmarine.com ” - 250 x 100 mm.
iv. 1 off per FROG-9 Rectangle Reflex Marine Ltd Tel No “ +44 (0)1872 321155 ” - 250 x 100 mm.
v. Buoyancy columns numbered "A, B, C" Arial bold 150 mm height, black on upper buoyancy.
vi. 3 off per FROG-9 Reflective tape (1 x 220 mm on upper buoyancy).
Link to Index