Reflex Marine FROG-9, User Manual

Page: 36 / 64

User Manual FROG-9
Rev 05 Page36
8. Landing Feet (replacement part as required)
Examine the feet to ensure that they are in good
condition and that they are properly secured to the
capsule. Do not go underneath an active lift.
Notes:
i. Measure height of outer foot and replace if under
120 mm in height
ii. Measure height of inner foot and replace if under
150 mm in height
iii. Small (20 mm in length) cuts are acceptable but feet
should be replaced when the internal Foam becomes
visible
9. Seat Harness Security (Critical Part)
Visually inspect the seat harness attachment points and
the harness webbing for any signs of wear, fraying or
damage. Check that the attachment points are secure.
10. Seat Harnesses (sit-in)
Check all seat harness buckles to ensure each is
functioning correctly. (Inspector to sit in each seat and
check fastening and unfastening of each harness).
11. Load Test Plate (replacement part)
Renew the load test plate after completion of approved
load test.
12. Lifting Sling Set (Critical Part)
Replace the sling set according to the usage of the FROG
(see Table 3 in
Section 6.3 ). This may be as frequently as
every 3 months. Irrespective of apparent condition the
lifting sling set should be replaced at least every 12
months.
Check the anti-fouling tie wraps or the back-up eye
shackle insert are in good condition (see
Section 5.4.2 ).
Replace as necessary.
13. Full Load Test (see Section 6.8 )
A full load test must be conducted by an independent
test house company, nationally recognised and in
accordance with ILO 152.
14. Post Load Test Visual Inspection (See Section 6.7 )
Conduct and report a post load test visual inspection.
15. Photographic Report
As an inspection record aid, the critical elements and
condition of the unit may be recorded in photographs;
Photographs of each of the 14 points of the check list
would provide a concise inspection record. Photographs
should be clearly marked pre and post inspection as
appropriate.