User Manual
FROG-9
Page35
Examination Checklist Form
Unit No
This Examination Date
Usage Category
Last Inspection Date
Installation / Vessel
Last Examination Date
Avg No of Transfers / Year
Load Test Performed
Y/N
Inspect
No
Description
Comment
Pass / Fail /
Replaced?
1.
Main Lift-Eye Plug
(Critical Part)
Remove and visually inspect the main Lift-Eye plug for
any signs of damage or strain. Replace according to the
usage of the FROG-9 (see Table 3 in
) or on the
recommendation of a Competent Person / Inspector.
2.
Main Lift-Eye Plug M24 Bolts
(Critical Part)
Remove and visually inspect the three M24 main Lift-Eye
plug securing bolts for any signs of damage or strain.
Visually inspect the three M24 holes in the lifting bolt
retaining sleeve and in the central column tube for signs
of damage or strain. Replace appropriate parts according
to the usage of the FROG-9 (see Table 3 in
) or
on the recommendation of a Competent Person /
Inspector. Bolt torque to 376 Nm.
3.
Back-Up Lift-Eye (replacement part as required)
Inspect the back-up eye in situ, nut, split pin and tamper
proof seal. Replace on the recommendation of a
Competent Person / Inspector
.
4.
Handling Lift-Eye (replacement part as required)
Inspect the back-up eye in situ, nut, split pin and tamper
proof seal. Replace on the recommendation of a
Competent Person / Inspector.
5.
Seat Base Assembly and the Hydraulic Damper and
Anti-Tilt Assembly (replacement part as required)
Visually inspect and test all fixings for any wear or
damage and ensure that all bolts, clevis’ and other
fasteners are fully secure. Ensure that the damper rod-
end threads are not visible below the clevis pin eye. (see
Technical Bulletin 01-09 at
http://www.reflexmarine.com/index.cfm/p/Technical-
Safety-Alerts
).
6.
M72 Keel Boss and M10 Cross Bolt
(Critical Parts)
Remove the M72 keel boss nut and visually check that
the threads at the bottom of the central column tube are
in good condition. Replace appropriate parts according to
the usage of the FROG-9 (see Table 3 in
) or on
the recommendation of a Competent Person / Inspector.
Do not go underneath an active lift.
7.
Frame and Buoyancy (replacement part as
required)
Visually inspect for any damage and ensure that all bolts
and fasteners are fully secure.
Summary of Contents for FROG-9
