Installation Instructions
Snap Up Bracket
TOOLS NEEDED:
Drill Bits:
7/16”, 9/16” & ¼”
WARNING:
Read all instructions before installing the additional bolt.
Failure to follow all of these instructions may result in death or serious injury!
2-1/4”
•
Installation of an additional bolt into the snap up bracket when using
a Jayco RV with a coupler mounted to the bottom of the frame.
•
If a hole does not already exist, mark the location of the hole to be
drilled into the snap up bracket. Center the hole from left to right and
place it 2-1/4” above the arc in the bracket. See the picture at left.
•
Before the bracket is placed on the frame, drill a 9/16” hole in the
bracket
•
Place the bracket in the correct place on the frame as directed in the
product instructions or replace it where it was if it had already been
installed.
•
Using the hole in the bracket as a guide, drill a ¼” pilot hole. Be sure
to stay centered in the bracket hole.
•
One method to stay centered is to use the 9/16” drill first. Just put a
small dimple into the frame with the 9/16” bit. Then finish drilling
with the ¼” drill bit and then a 7/16” drill bit to get the final hole. See
pilot hole to the left.
•
Install the ½” self tapping screw into the hole in the bracket and
frame. Tighten it to 50 ft/lbs.
•
Re-tighten the ½” set screw on the inside of the frame. Turn only
¼ to ½ of a turn after making contact with the frame.
PARTS LIST
QTY
DESCRIPTION
2
1/2" x 1.00" SELF TAPPING SCREW
1
INSTRUCTION SHEET
