PowerLift
by ReechCraft
30
Because the ReechCraft PowerLift is a modular operator assembled machine, the
platform, each outrigger and mast section can be removed to reduce weight as the
situation requires.
NOTE:
For the purposes of this section, it is assumed that the machine is in it’s
fully stowed configuration.
Getting Started
1. Place the machine on a firm, stationary surface capable of supporting the
intended load directly under the desired work area.
2. Connect to an appropriate power source. AC: connect to a grounded
15A AC power supply. Be careful the extension cord remains slack at
maximum height and does not become entangled in the machine which
may lead to electrical shock or instability.
3. Install front and rear outriggers in their designated positions. Using the drill
and hex driver, level the chassis by adjusting each of the leveling jacks, until
the bubble level is centered. (See Figure 3-3)
SECTI
ON
3
MACHINE OPERATION
3.4
Machine Setup
Figure 3-3
Proper Set Up
