27
8) Replacing the Spindle Belt
The spindle belt transfers the rotation power of the spindle motor to the spindle to turn the
engraving blade. If the spindle belt is worn, the surface is cracked and slippery. So it cannot
deliver the power of the spindle motor properly. In this case, the number of rotation decreases,
or it causes poor engraving quality.
Replacement Cycle
:
The lifespan of the spindle belt varies depending on usage and conditions. Generally, it should be changed every
2-3 months.
Spindle Belt Replacement Method
There is a red rubber belt on the front head of the engraver. Replace this belt with new belt.
9) Tension
◈
Setting Engraver Pressure Lock
When cutting materials or engraving materials with a V cutter, set the head and remove the pressure lock. Then,
vibration during engraving will be reduced and it will improve the quality of engraving or cutting and extends the
life cycle of the tool. Release the bolts as shown in the picture below and insert the hole in the back and turn it to
tighten.
After that, when engraving with the Carbide tip tool, it needs more pressure. So this bolt should
be released and moved to the left hole.
Spindle belt
Summary of Contents for R&D MAGIC-70
