AN-50e
user manual
70-00033-01-03
Proprietary Redline Communications © 2005
September
2005
Page 58 of 100
VID (Connection VLAN ID field) for with this connection. Only one pass-
through connection can be defined for each subscriber station.
Note: If a pass-through group is not configured, all untagged packets received
at the subscriber station Ethernet ingress port are discarded.
Packet received from subscriber station Ethernet ingress port:
The packet is forwarded unmodified over the wireless to the sector controller.
Further processing is performed at the sector controller based on the group
configuration associated with this connection.
Packet received over wireless interface (from sector controller):
The packet priority is set (default priority field). The packet is forwarded to the
Ethernet port.
Connection VLAN ID
: Enter the VLAN ID tag associated with this connection
definition. This field is used only when 'Tagged' is selected in the Connection
Tagging Mode field.
Default priority
: Enter the default 802.1p priority setting.
The default priority setting is used only when the Connection Tagging is set to
'pass-though' mode and the associated Group Tagging Mode is set to 'Tagged'. In
this case, there is no priority information available from the subscriber station
ingress packet, and the connection Default Priority value is used when adding the
802.1Q tag (Group VLAN ID) to the packet being forwarded to the sector
controller Ethernet (egress) port.
Link ID
: Enter the link ID for this connection.
Group ID
: Enter the group ID for this connection.
Wireless Traffic Parameters
DL QoS Level
: Enter the bandwidth weighting value for all downlink unicast
traffic. The sector controller allocates bandwidth for all subscriber stations using
the Weighted Round Robin algorithm, with the aggregate user-configured DL QoS
Levels acting as weights. The following table provides recommended settings for
the QoS and SINADR when configuring a PMP system.
Table 20
:
Web - PMP QoS and SINADR Settings
Uncoded Burst Rate (Mbps)
SINADR (dB)
54
25
48
23
36
18
24
15
18
11
12
9
9
9
6
7
UL QoS Level
: Enter the weighting value for downlink unicast traffic.
See DL QoS Level above.
