7
www.redbacklasers.com.au
Turning Laser On
Press Power button on the keypad to turn on the CXR880™, power
LED will light. Batteries are low if power LED flashes. After turning the laser
on, the laser will auto level and start to rotate. The power button on the
remote will not operate until the laser has been powered up from the keypad
direct, the power button on the remote then acts as a standby button. The
CXR880
TM
has a large self levelling range, however, if the laser happens to
be set up outside this range a warning will sound and lasers flash. Re-set
the laser more level using bubble vial and adjustment feet on tripod mount
if fitted or level on survey style tripod.
Tilt Mode
Tilt mode is somewhat similar to tilt on a pinball table in that if when running
the CXR880 detects significant disturbance or movement that could effect
the accuracy of your work the laser will “Tilt” (stop working) and the laser
beams will flash to indicate this. You will need to then re level the laser
by either pressing the level button on the remote or pressing the tilt
button twice on the keypad, wait a few seconds to level and then re-
check your work to maintain maximum accuracy.
Tilt mode is defaulted to being
ON
and will automatically activate 30 seconds
after the laser has been powered up and the LED above the Tilt button will
light to indicate it has been activated.
To deactivate the tilt mode press the tilt button the LED above it goes
out. It is recommended to use the laser with tilt mode set on when using
the rotating laser outdoors and turned off the tilt mode for indoor or line
use, this will allow time for aligning the lines without tilt mode kicking in and
forcing you to re-level. Tilt de-activates in Slope(grade)/Manual operation.
Summary of Contents for CXR880
Page 1: ......
