5. Attach the top vent scoop to the BRAIN by installing four (4) M3x0.5 x 6 mm cap screws with a T8 TORX driver.
DO NOT FULLY TIGHTEN.
WARNING:
DO NOT OVERTIGHTEN.
Figure: Install Cap Screws
6. Tighten the M3x0.5 x 6 mm cap screws evenly. DO NOT exceed 30 in-oz, or damage may occur.
WARNING:
DO NOT OVERTIGHTEN.
7. Reattach any DSMC accessories that you may have removed from the BRAIN.
8. Upgrade your firmware or perform a hardware rediscover to ensure that your camera recognizes the new fan. For
more information, go to
"Configure Firmware" on page 27
NOTE:
The top fan may not run immediately after turning on the BRAIN, as the top fan runs when the BRAIN
requires additional cooling power.
NOTE:
If you need to replace any screws, submit a Support ticket at
C O PYR I G HT © 2 0 1 9 R ED.C O M , LLC
9 5 5 - 0 0 1 2 , R EV - N
|
2 0
DSMC FAN 2.0 UPGRADE INSTRUCTIONS