9. If the connector on your original fan assembly has a white tab, depress the white tab with the ESD-safe solder
stick and gently pull the cables until the connector is free.
If the connector does not have a white tab, gently pull the cables until the connector is free. Use the ESD-safe
solder stick for assistance if necessary.
Figure: Disconnect Fan
INSTALL 2.0 BOTTOM FAN
NOTE:
If any of the fan bumpers fall off of the fan assembly during the installation process, reattach the bumpers and
ensure that they are properly aligned.
1. Identify the new fan assembly.
2. Align the female connectors with the pins in the connector slot and verify the following:
Verify that the blue wire is at the top, and the red wire is at the bottom.
Verify that the connector enters the slot directly, and NOT on its side, so that the female connectors align with
the pins in the connector slot.
C O PYR I G HT © 2 0 1 9 R ED.C O M , LLC
9 5 5 - 0 0 1 2 , R EV - N
|
1 1
DSMC FAN 2.0 UPGRADE INSTRUCTIONS
