RED Dalia Oyster, Use And Maintenance Manual

Page: 33 / 44

PELLET STOVES Chapter 4
red
INSTALLATION AND USE MANUAL
page
33
Operation Technical service - Rights reserved - Reproduction prohibited
4.16.
SAFETY DEVICES
The stove is fitted with the following safety devices:
 MAIN STOVE POWER SUPPLY SAFETY
The stove is protected by a fuse which is near to the switch (I).
 SMOKE TEMPERATURE SENSOR.
Monitors the temperature of the smoke, and gives permission for
start-up or shuts the stove down when the smoke temperature
falls below the preset value.
 PELLET HOPPER TEMPERATURE SENSOR.
If the temperature exceeds the preset safety level, it immediately
shuts down the running of the stove, and has to be reset, after the
stove has cooled, before the it will restart.
 ELECTRICAL SAFETY
The stove's electronic board is protected by a fuse. (see section.7).
 FAILURE OF THE SMOKE EXTRACTION FAN
If the fan stops, the electronic board shuts off the supply of pellets
in good time, and an alarm is displayed.
 BREAKDOWN OF THE REDUCTION MOTOR
If the reduction motor stops, the stove continues to function until
it has cooled down to the minimum level.
 TEMPORARY POWER CUT
If there is a power outage during operation, when the power
comes back on the stove will go into cooling mode.
 FAILURE TO LIGHT
If during ignition no flame develops, the stove will go into alarm
condition.
TAMPERING WITH THE SAFETY DEVICES IS
PROHIBITED
It is only after eliminating the cause which gave rise to the
intervention of the safety system, that it is possible to
relight the stove and thus reset the automatic operation of
the sensor. To understand which anomaly has occurred,
consult this manual which explains what to do based on the
alarm message the stove displays.
ATTENTION
If the stove is not used as described in this instruction booklet,
the manufacturer refuses to accept any responsibility for
damage to persons and property that may arise. The
manufacturer furthermore refuses to accept responsibility for
damage to persons and property arising from the failure to
observe all the rules contained in the manual and in particular:
 Failure when carrying out works of maintenance,
cleaning and repair to adopt all necessary measures and
precautions
 Tampering with the safety devices.
 Removing the safety devices.
 Failure to connect the stove to an efficient system for the
discharge of smoke.
 Failure to check in advance that the room where the
stove is to be installed is adequately ventilated.