PELLET STOVES
Chapter 4
red
INSTALLATION AND USE MANUAL
page
24
Operation
Technical service - Rights reserved - Reproduction prohibited
4.4.
DISPLAY PANEL AND COMMANDS
4.4.1.
Control panel logic
Shown below is some useful information for understanding the logic
and use of the control panel:
Knob
A
has 5 ventilation levels. The knob rotates uniformly
from min to max.
Knob
B
allows the room temperature to be regulated. The
temperature ranges from a minimum of 15°C to a maximum of
30°C, also in this case the knob turns uniformly.
Knob
C
foresees 5 levels of flame regulation (power); the key
rotates uniformly.
Key
D
allows the stove to be ignited (ON) or shutdown (OFF).
Key
E
increases or decreases pellet load respect to the factory
default value which is 0. When the stove is lit for the first
time, the set setting is 0 (led in the middle), by using key
E
you increase (led to the right+1/+2) or decrease (led to the
left-1/-2) the pellet load. The selected led will remain fixed
orange while the stove is operational, it will go out when the
stove is switched off and the last setting will stay in the
memory when it is lit again.
Led 1
– when the stove is lit the led is green and fixed,
flashing green when igniting/setting the stove and flashing
yellow/orange when it is switched off; it flashes red in the case
of the intervention of an alarm.
The 5
leds
over key
E
(0
/
-1/-2/+1/+2) also light up to signal
alarms. In the event of an alarm,
LED 1
will flash red, an
acoustic signal will be emitted and the type of alarm will be
displayed by the corresponding
LEDs
.
