RED Dalia Oyster, Use And Maintenance Manual

Page: 42 / 44

PELLET STOVES Chapter 6
red
INSTALLATION AND USE MANUAL
page
42
Problems/Causes/Solutions Technical service - Rights reserved - Reproduction prohibited
PROBLEM
LED
POSSIBLE CAUSES Solutions:
The pellets
accumulate in the
grate  Pellet load too high
 Insufficient combustion area.
 Pellets damp or unsuitable.
 Door open
 Smoke outlet blocked
 Gaskets worn
 Increase the pellet load
following the instructions in
section 4.10
 Make sure that the
combustive air inlet in the
back of the stove is free
from obstructions or
blockages
 Remove the unsuitable
pellet from the hopper and
exchange it with one
recommended by the
manufacturer
 Check that the door is
properly closed
 Clean the smoke outlet
 Increase the smoke fan
speed according to the
technical manual
 Replace the faulty
component
The flame is weak
and goes out  The pellet hopper is emptying
 Low pellet load
 Unsuitable pellet
 Fill the hopper
 Increase the pellet load
following the instructions in
section 4.10
 Remove the unsuitable
pellet from the hopper and
exchange it with one
recommended by the
manufacturer
The room fan does
not stop  The stove is cooling down
 Temperature probe faulty
 Wait for the structure to
cool
 Replace the faulty
component
The room fan is not
working  The temperature has not reached the
minimum ignition limit
 The thermal protection has triggered
due to fan overheating
 Fan faulty
 Wait for the structure to
cool
 Check for any
impediments in the fan
rotation
 Replace the faulty
component
The room fan is not
regulated by knob A  The stove has reached the room temperature
set by knob B and automatically modulates at
minimum
 Control panel faulty
 Increase the temperature
set using knob B
 Replace the faulty
component
The stove power is
not regulated by
knob C  The stove has reached the room temperature
set by knob B and automatically modulates at
minimum
 Control panel faulty
 Increase the temperature
set using knob B
 Replace the faulty
component
No light signals on
the power supply
switch of the stove  The power supply cable is unplugged

The switch is not lit on I
 No voltage
 Fuse blown.
 Connect the cable to the
socket plug

Ignite the stove using
switch I
 Check the system
 Replace the fuses
(section.4.4)