Real Flame ELEMENT 1800 DOUBLE SIDED, Installation & Operating Manual, Page: 52 / 60

52
INJECTOR AND PILOT REMOVAL INSTRUCTIONS
Appliance supplied as Natural Gas only
TOOLS
• 10mm spanner
• 15mm spanner
• 16mm Spanner (recommended) or small/medium shifter
• No. 2 Phillips head screwdriver
• Allen key 2.5mm AF
Burner
1. Turn appliance off and allow to cool.
2. Turn off gas to appliance
3. Turn off and isolate appliance from electrical supply
4. Remove trim screws and remove inner door trim
5. Remove door retaining screws
6. Hinge door forward and lift out – Door is heavy and recommended as a two person operation.
7. Remove media where fitted. Carefully not to damage or break logs.
A dust mask is recommended to be worn
8. Remove burner media support tray
9. Remove burner fixing nuts ( 2 off at ends of burner).
10. Lift burner up and gently support.
11. Undo gas connection pipe at end of burner. (15mm and 16mm spanner required).
12. Lift burner out gently. Keep burner in the flat position until insulation is restrained.
(Rotating the burner may cause insulation to fall and be damaged.)
13. RECOMMENDED STEP
To avoid damage to the insulation apply low tack tape to the burner to restrain the insulation into
position. Avoid pressing the tape onto the media. The insulation media may easily crack if the
appliance has been operated for several hours.
The media may be carefully lifted out and placed flat to store until refitting.
The media can be repainted using an approved high temperature paint, contact Real Flame for
details.
14. Turn burner over gently. AVOIDING DAMAGING THE INSULATION.