www.ReadyLIFT.com
-
Phone: (877) 759
-
9991
3
44
-
3060/44
-
3080IM
-
AC
IMPORTANT NOTE:
The 44
-
3060 kit was developed using a
37x12.5
tire with
20x9
”
wheel offset of 0.
The 44
-
3080 kit was developed using a
37x12.5
tire with
20x10
”
wheel offset of –
18
.
If wider tires are used, offset wheels may be necessary and trimming may be re-
quired. Factory wheels can be used but are not recommended with tires over
11.5”
wide.
The stock spare rim can be run in an emergency
-
exercise extreme caution under
stock spare tire operating conditions. Please note that, if running the spare factory
tire, it is done for short distances and a speed not to exceed 45mph or damage to dif-
ferentials may occur. The Stock spare wheel may not fit the on the front axle due to
over sized steering knuckles. If you encounter a flat on the front axle move one of the
rear wheels to the front and use the spare on the rear.
A lifted vehicle may have different headlight aim performance.
ReadyLIFT recom-
mends marking and recording the headlight beam position before kit installation and
then adjusting, if necessary, the headlamps to the same height settings after kit in-
stallation.
Set the vehicle on a level surface 10' to
15’
from a solid wall or garage
door.
(This is a general distance with some manufacturers requiring different distanc-
es.)
Note the top height of the low beam's bright spot, the top of the most intense
part of the beam, for driver and passenger side.
Height may vary from side to
side.
Repeat this procedure and adjust after lift kit is installed.
Adjust if the aim is off
by turning the adjusters gradually (a quarter of a turn) and looking to see where the
new alignment falls.
It may be easier to block one headlamp while adjusting the oth-
er.
Consult the owner operation manual for procedures to adjust headlights
-
many
automakers offer headlight aiming specs.
Some states have their own specifications
when it comes to headlight aim, so it
’
s best to follow those rules when alighting head-
lights.
This kit requires the removal and installation of the torsion bar arms. ReadyLIFT rec-
ommends to use our Torsion Key Unloading tool or similar.
ReadyLIFT SKU: 66
-
7816A
When setting the torsion key adjustment bolt do not exceed
30”
for the 44
-
3060 kit
and
32”
for the 44
-
3080 kit. Measure from the wheel center to the fender edge. Ex-
ceeding this will create a top off condition, meaning the suspension has little to no
down travel. The result is poor ride quality, and premature failure of components.
There are a few extra steps included in this manual that pertain to the 44
-
3080 kit.
These steps will be clearly marked. 44
-
3060 lift kit discard these steps.
