Cleaning the Printer
Every few months, examine and clean the printer by following these steps:
CAUTION:
Always disconnect the unit from its power source before cleaning the printer.
1.
Swing open the clear plastic paper roll cover at the back of the unit.
2.
Lift out the paper roll. Cut the paper that is in the feed mechanism from the roll.
3.
Press the latch and lift open RDM SYNERGY II’s cover.
4.
Toward the back of the unit, locate the paper slot and the gray lever on the right side of it.
Flip the gray lever up and toward the front of the unit to release the paper.
5.
Manually remove the remaining paper from the feed mechanism. Carefully remove dirt, dust,
or scraps of paper stuck in or to the printer parts.
6.
Flip the gray lever back into place. Close the cover again.
7.
Re-install the paper roll as described in the “Setting Up RDM SYNERGY II - H: Install the
Printer Paper Roll” section.
20