NoKey Force – Installing and Operating
Installing the outer and inner unit
11
4.4
If the door is thinner than 39 mm, a
spacer plate is needed on the rear of the
inner unit (see page 6.)
The spacer plate is screwed on to the
rear of the inner unit with the
accompanying screw (Torx T15).
4.5
Insert the square pin into the inner unit,
with the rounded end facing outwards.
Select the correct hex pin and insert it
past the square pin, turn it back and
forth a few times and ensure that it
grips in the mechanism.
Door thickness Length of
hex pin
38 – 58 mm
80 mm
58 – 81 mm
100 mm
81 – 110 mm
130 mm
130 mm hex pin ordered separately.
4.6
Thread the cable with its contact
through the oblong hole down to the left
in the inner unit.
Ensure that the cable runs freely and
does not get trapped when the units are
later screwed tight.
Spacer plate
Rounded
