6. Command Reference of RPCM CLI
6.5.2. Command
restart
high-level-controller
Additional information. RPCM uses 3 controllers:
High Level Controller (HLC)
, where is the software is running,
Low Level Controller (LLC)
, which operates under the firmware
Display Controller,
where the Display Firmware is running.
Low Level Controller
is responsible for electronic operations such as input and outlet management, ATS (except RPCM ME
1563 ), meters, overload and short circuit protection.
Low Level Controller
works under the control of
Firmware
.
High Level Controller
responsible for the user interface, including web interface, SSH CLI, REST API, SNMP and so on.
High
Level Controller
runs under
Software
.
Display Controller
is responsible for external indication.
For the user available is the option:
restart high-level-controller
This construction is used to restart
HLC
, for example, during the update procedure.
In return, the system issues a request to confirm the reset:
Please enter 'RESTART' (ALL CAPS MANDATORY) and press ENTER to restart High Level Con-
troller immediately, or anything else to cancel:
After entering the command:
RESTART
You will receive a proposal to restart the SSH CLI session:
Please disconnect your SSH session manually... Restarting High Level Controller in 5 sec-
onds ...
WARNING! If the mode of obtaining an IP address is via DHCP or by means of auto-assignment (Zero Configuration Net-
working), then the IP address after the reset may change.
To prevent this situation, we recommend using the binding function to bind IP address to the MAC address on the DHCP
server.
For information on the operation of this design, refer to section "
4.7. Updating the RPCM soft-
ware
".
245
