Operator Unit 130-626.NG002
Standard 22 GYRO COMPASS
2-2
2.2
Setting into Operation
Precondition:
The Operator Unit has to be configured for CAN-Bus operation with the Configuration Tool
AS.
1.
Switch on the power supply to switch on the Operator Unit.
2.
Make sure that the Operator Unit starts.
2.2.1
Heading Indication from Gyro System after Switching on
During the first 3 minutes after switching on (heating stage) it is
possible to activate the quick settling function (see chapter 2.9.6).
The switching on process is divided in the following stages:
(May vary depending on the connected gyro system.)
•
Heating stage
•
Settling stage
Heating Stage
During the heating stage of the gyro system the heading information is not valid, which is
indicated by a set of dashes (- - - .-
°
). The heating stage is displayed below the heading
information (see Figure 2-1).
If a second gyro is connected, the heating stage is indicated with “(heating)” next to
heading information of the unselected gyro.
Figure 2-1
Heating Stage
