Raytheon Anschütz Pilotstar D, Manual

Page: 118 / 166

PILOTSTAR D
4--14
3060.DOC012
Edition: March 13, 2009
17.3 Press the
Auto
On/Off
key. The
Auto
On/Off
LED should now illuminate and the rudder will
move to zero degrees.
The ”SET HEADING” display should match the heading indication in the upper left
corner.
17.4 Increase the SET HEADING about 10

port (using the heading setting knob).
The rudder should now move to approximately 10

port.
17.5 Press the
Trim
Man
key. The LED should now illuminate (operating mode Man ual
control is active).
The rudder should return to zero.
17.6 Press the
Auto
On/Off
key. The LED should now illuminate (operating mode Auto matic
control is active).
The rudder should remain at zero degrees.
17.7 Increase the SET HEADING about 10

starboard (using the heading setting knob).
The rudder should now move to approximately 10

starboard.
17.8 Press the
Trim
Man
key. The LED should now illuminate.
The rudder should return to zero degrees.
18. At the navigation receiver, enable the output sentence selected in step #9 --NAV
TYPE.
The ”TRACK HEADING” should be +/-- 60

of ship’s heading.
18.1 Press the
Track
key. The LED should now illuminate.
The audible alarm will sound.
The text line will now display ”XTE meter ......” indicating the cross track error for
approximately 3 seconds.
This will be followed by the message ”NEW TRACK XXX” which indicates heading
of the track.