-33-
Voice Control
TellPhone 5000
•
Sit in a normal driving position behind the steering wheel and, keeping your
eyes on the road, speak as soon as the connection has been set up. Ask the
person you are calling if he hears any echoes. If he does, try turning down
the volume or reducing the sensitivity of the microphone.
•
End the connection by pressing the red Key on the Control Unit.
•
Dial a number via voice control and end the connection via the red button
•
Store a name for voice-command control and then call the number by voice
command. Let him end the call.
•
Store an emergency number by means of voice command.
Voice Control
Our interactive voice control allows names and numbers to be dialled by voice
commands, whereby name dialling is speaker-dependent. While number
dialling requires you to say the number you are calling directly, name dialling
requires you to set up and manage a list of names "phone book" in the system.
The functions required for this can also be called up by voice input. The list can
take a maximum of 30 names and exists independently of the list of phone
numbers in your phone.
Changing the recognizer language
Depending on the country variant of your TellPhone 5000, voice recognition
supports up to 3 languages, one of which may be activated. To change the
active recognizer language, select Settings => Recognizer language. A list of
the available languages is displayed. Select the required language and confirm
by pressing the rotary encoder. You will then be prompted to restart TellPhone
5000. You can do this by switching off the ignition. The system will now save
your settings and start to update the recognizer language. A progress bar
indicates the status of this process.
Activation and Process Sequence
Voice input is only possible when there is no call connection. In this state, if the
rotary encoder is pressed for longer than half a second the ready tone will
sound, after which it will be possible to input an initial command. If a Bluetooth
®
telephone is not connected to the system, commands that require this
connection, in other words all the dial commands, will be rejected by the system
with a corresponding voice output. You can abort any voice dialog at almost any
point by again holding down the rotary encoder. If the system is waiting for a
voice command, you can also end a dialog by speaking the command “Cancel”.
Summary of Contents for TellPhone 5000
Page 18: ...18 TellPhone 5000...
