-12-
TellPhone 5000
Installation
Attaching the microphone
Decide on where to mount it
There is a self-adhesive strip on the rear of the
microphone holder. In shape and size the
bearing surface must suit the adhesive surface
of the microphone holder. The connecting
cable must extend up to the electronics box!
Position the microphone with its speaker
opening facing the direction of speech. The
picture on the right shows a possible mounting
position for the microphone. Alternatively, the
microphone may also be attached to the sun
visor by means of the clip included in the scope
of supply.
Clean / remove grease from the sticking surface
Adhesive surfaces must be free of grease and dust. Clean the designated surface
with a suitable detergent such as spirits. Only use detergents which do not
dissolve plastics or varnished wooden surfaces and which are not greasing
themselves. Unsuitable agents are e.g. cleaning grade petrol, acetone,
turpentine, trichloroethylene and similar detergents.
Sticking on the microphone holder
Pull the protective foil off the adhesive strip. Hold the microphone holder at a
distance of some millimetres over the desired mounting position. Check the
position again. It will not be possible to correct the position once the holder is
stuck on. Place the microphone holder on the adhesive spot and press briefly
with moderate strength.
Mounting the microphone
Mount the microphone by putting it on the holder and aligning it in the direction
of speech.
Attaching the display
The display can be attached in a number of different ways and can therefore be
adapted to a wide range of mounting positions within the vehicle.
Damage of important vehicle components
Drilling mounting holes or driving in self-tapping screws may cause
damage to important vehicle components or to cables. Make sure
there is enough space left also behind the screws und drilling holes!
Summary of Contents for TellPhone 5000
Page 18: ...18 TellPhone 5000...
