-
Threshold Setting
•
Initial Sat Count
: Set the threshold count for maintaining
tracking.
•
Set Verify Time
: Set the time of verifying whether the signal
detected is the signal of target satellite.
•
Voltage Threshold
: Set the voltage threshold. The voltage
threshold is to distinguish the voltage between 13V and 18V.
•
DiSEqC Threshold
: Set the DiSEqC threshold. The DiSEqC
threshold is to distinguish the 0KHz tone and 22KHz tone.
•
WRS Detect Level
: Set the WRS detection level.
-
Flag Setting
•
Use WRS Method
: Use WRS method is to determine
whether the system uses “WRS Detect Level” or not. Use
WRS method and “WRS Detect Level” are pair functions.
•
Use Offset Difference
: Use offset difference is to
determine whether the system uses “Offset Difference” or
not. Use Offset Difference and “Offset Difference” are pair
functions.
•
Use DiSEqC 1.2
: Use DiSEqC 1.2 is to determine whether
the system uses the “DiSEqC 1.2” protocol or not.
3. Satellite (Satellite View)
The name, longitude, verification method of the satellite and
LNB local frequency are displayed.
-
LNB Local Frequency
: Displays or sets LNB local frequency
and its corresponding LNB voltage supplied. You may select
pre-programmed LNB LO settings from the drop down list.