Raymarine Satellite TV Antenna Systems
Securing Holes for Bolts and Cable Ways
Make 4 bolt holes of 10mm diameter, one at each corner of a
rectangle drawn as below, and make a circular hole of 80mm
diameter at the center of the rectangle through which the
cable will run.
Connection of the Cable
Remove the rubber cap from RF connector. Connect the RF
cable to the RF connector under the base plate through the
access hole using an 11mm spanner. Be careful not to over
tighten, as you may damage the connector.
Figure 13 : Connectors on Bottom of Antenna
Note:
Do not use excessive force or overtighten when using
the spanner, as this will damage the threads. Be careful that
the connectors do not touch the mounting surface of the
antenna, this might cause a critical malfunction and serious
damage to the equipment.
Ø80mm
Hole Saw
Ø 10mm
Drill
Figure 12 : Drilling Instruction
Antenna Unit
RF1 Cable
Optional
11mm
Spanner