Raymarine ST70 Instrument, Installation Manual

Page: 34 / 73

24 ST70+ User Reference Manual
Date & Time
The Time & Date summary page shows the current
values applied to your ST70+ system.
Note:
If your display is not receiving GPS information, the Time
& Date page is not displayed. In this case, proceed with
the Data units setup procedure below.
Check the information, on the Time & Date summary
page, then press
OK
to display the Time & Date
setup menu.
You can change certain date and time parameters. You can:
•
Select either dd/mm/yy or mm/dd/yy as the date format
• Select either 12-hour (am/pm) or 24-hour as the time format.
• Set the value of the time offset to give the required local time.
If you want to change any Time & Date values, carry out the Setting date format ,
Setting time format and/or Setting local time procedure below, as appropriate.
If you do not want to change any Time & Date values, proceed from Leaving date &
time setup below.
Setting date format
To set the required date format:
1. At the
Time & Date setup menu, scroll to the Set
date format option, then press
OK
to display
the Set date format page.
2. Scroll to select the required Date Format, then
press
OK
to save the format and return to the
Time & Date summary page.
3. Press
OK
to select the Time & Date setup menu.
Setting time format
To set the required time format:
1. With the Time & Date setup menu displayed,
scroll to select the Time Format option, then
press
OK
to display the Set time format page.
i
D1
1
149-1
Press OK to continue
Time & Date
These are your current settings.
10
Time 11:01:03
Date 14/06/07
Time Offset -1 Hrs
Time Format 24-hour
Date Format dd/mm/yy
D1
1
153-1
Time & Date
Set date format
Press OK to select
10
i
D
111
5
4
-1
Press OK to accept
Set date format
Use < & > to adjust.
CANCEL exits without saving.
dd/mm/yy
10
D1
1
155-1
Time & Date
Set time format
Press OK to select
10
87099_1.book Page 24 Thursday, March 12, 2009 10:18 AM