Raymarine ST70 Instrument, Installation Manual

Page: 49 / 73

Chapter 3: Commissioning Procedures 39
4. Scroll to select the required mode:
• Select ON if you want to set a value for variation. if you choose this mode, the
value you set will be applied to the rest of the system.
• Select OFF if you do not want to apply a variation value to the system.
• If SLAVE is displayed in the mode adjust box, the variation has been set at
another product in the system, and the value is shown in the lower adjust box. In
this mode. In this case you cannot change the variation value.
5. If you selected the OFF or SLAVE mode, proceed from step 6. If you selected the
ON mode:
i. Press
PAGE DN
to select the lower (value) box.
ii. Scroll to set the correct variation value.
6. Press
OK
to save the value and return to the Advanced Options menu.
7. Press
CANCEL
to return to the Main Menu .
Now proceed to Changing response rate .
Changing display response rate
The display response rate determines the rate at which data readings update. You
can adjust the response independently for each display and for individual data types,
to best suit the conditions under which you are operating.
If you want to change the response at any display:
1. With the
Main Menu displayed, scroll to Display
Settings.
2. Press
OK
to display the Display Settings menu.
3. At the Display Settings menu, scroll to the
Response option.
4. Press
OK
to display the Response menu, then
scroll to the required data type ( Speed shown
here).
5. Press
OK
to display the response adjust box for
the data you have selected.
6. Scroll to set the response rate. A higher value
gives a quicker response rate and vice versa.
7. Press
OK
to save the value and return to the
Response menu.
i
D1
1
184-1
Display Settings
Response
Select display response.
Press OK to select
D1
1
1
85-1
Response
Speed
Press OK to select
i
D1
1
186-1
Press OK to accept
Speed
12
< & > adjust response level.
CANCEL exits without saving.
87099_1.book Page 39 Thursday, March 12, 2009 10:18 AM