Raymarine ST70 Instrument, Installation Manual

Page: 37 / 73

Chapter 3: Commissioning Procedures 27
Initial setup end routine
If the function of any display has changed since switch on (i.e. Instrument to Pilot
Controller or vice versa), the relevant displays reboot when you press
OK
at the Select
units menu.
When any necessary reboot has taken place, an operational page for either an
Instrument or a Pilot Controller is displayed, depending on which display function you
set previously. The display is now in operating mode.
Next actions
Now carry out the remaining dockside setup procedures.
3.3 Dockside setup
Carry out the dockside setup procedures in the following sequence:
• Autopilot system.
• Transducer setup.
• Miscellaneous setup.
Autopilot system
CAUTION:
Before starting any dockside setup procedure, ensure the boat is securely
moored alongside.
The autopilot dockside setup procedures comprise:
•
Using the Dockside wizard to:
• Set drive type.
• Perform motor phasing check.
• Perform rudder check.
• Setting rudder hard over time.
The exact procedures are dependent on the type of autopilot. Typical procedures are
given here, but you may need to adapt these procedures to suit your installation. If you
require advice or assistance, please contact your local Raymarine dealer.
Dockside wizard
Starting the wizard
At a convenient Pilot Controller:
1. Press
MENU
to display the Main Menu .
2. Scroll to Autopilot calibration then press
OK
to display the Autopilot Autocalibra-
tion menu.
87099_1.book Page 27 Thursday, March 12, 2009 10:18 AM