28
ST60 Tridata Instrument Owner’s Manual
2. Use the three self-tapping screws to attach the sensor directly to the transom
(or a fabricated mounting base).
3. Remove the pin securing the steering arm to the power steering.
4. Fit the Raymarine steering pin and retain with a split/cotter pin.
Note:
If your boat has a Volvo steering system, you should fit the plastic spacer to the
steering pin (as shown in the following illustration) so the pin does not foul the steering
system.
Figure 4-6: Typical Volvo installation
5. Cut the threaded connecting rod to length.
6. Screw the lock nuts and sockets onto the connecting rod.
7. Press the sockets onto the steering pins.
8. Turn the steering from side to side to make sure that the linkage is free from
obstructions at all angles.
D1991-2
Plastic sleeve
Steering arm
Raymarine steering pin
81057_6.book Page 28 Tuesday, February 21, 2006 2:21 PM
