42
RC435 and RC435i Chartplotters
Anchor Alarm
The selected value is used as the anchor alarm distance. If the vessel
moves outside of the selected distance from its position (at the time that
the alarm was enabled) the alarm sounds and an alarm message is
displayed.
To silence the alarm, press any key. This removes the warning and resets
the distance. The alarm will not be triggered again unless the vessel
moves the selected distance from its position (at the time that the alarm
was turned off). The alarm is set to
OFF
on power up.
XTE Alarm
The selected value is used as the cross track error limit. The alarm is
triggered when the cross track error exceeds the selected limit when a
GOTO
or a Route Follow is in progress and an alarm message is displayed.
Select Chart
Use
SELECT CHART
to access different charts from the same Gold Card.
Use the trackpad up/down buttons to select the desired chart and press
ENTER
to load this as the active chart.
Note:
Only one chart can be active at any one time.
Chart Text
When ON, Chart text (such as place names) are shown on the screen. The
selected setting is retained when the unit switched off.
LOAD
CHART
"ENTER" TO LOAD
"CLEAR" TO QUIT
D6249-1
1G737T32-FLORIDA SE
