0049-1800-xxx 326X V.34, V.34-SDC and V.32bis Series Modem – USER’S GUIDE 02/23/2010
Rev. A
Page 148
of
205
DIAL LINE, LEASE (PRIVATE) LINE, PHONE CONNECTOR PINOUTS
DIAL LINE, LEASE (PRIVATE) LINE, and PHONE connector pinouts vary by country. Consult Appendix
C for your country’s pinouts.
NC (NETWORK CONTROL) PORT PINOUTS
Table B-3 describes the pinouts for the IN and OUT NC (Network Control) ports.
“In” signals use a DCE-type interface. This type of interface connects directly to the
DTE-type interface provided by Raymar-Telenetics’ Network Management Systems.
“Out” signals use a DTE-type interface. This type of interface may connect to a
Raymar-Telenetics or Motorola network-managed product.
Cabling
This section provides important information about cabling and operating the modem at DTE rates
greater than 19.2 kbps.
NOTE
: 326X
FAST
and 326X
FAST
-SDC Series Modems are referred to as 326X Series Modems here.
Caution
When operating the modem at DTE rates higher than 19.2 kbps, carefully follow
the information here to determine the cables to use with your application. For the
modem to operate as specified, Raymar-Telenetics has indicated the maximum
capacitance of cables to be used when operating at data rates higher than 19.2
kbps. If this method is not followed, your modem may cause errors in data
transmission. Raymar-Telenetics makes no guarantee of proper modem operation
if you do not use a cable with the correct capacitance.
