0049-1800-xxx 326X V.34, V.34-SDC and V.32bis Series Modem – USER’S GUIDE 02/23/2010
Rev. A
Page 187
of
205
U.S.A.
FCC Registration
This equipment complies with Part 68 of the FCC rules. On the bottom of your 3260, or 3261 Modem,
the nameplate label contains the FCC registration number and ringer equivalence number (REN) for
your modem. If requested by the telephone company, you must provide this information.
This equipment supports the following USOC service codes (switched analog dial): RJ11C, RJ16C,
RJ45S, and RJ4MB.
The REN is used to determine the number of devices that can be connected to the telephone line.
Excessive RENs on the telephone line may result in the devices not ringing in response to an incoming
call. In most, but not all areas, the sum of the RENs should not exceed five.
To be certain of the number of devices that can be connected to the line, as determined by the total
RENs, contact the telephone company to determine the maximum REN for the calling area.
If this equipment causes harm to the telephone network, the telephone company will notify you. If
advance notice is not practical, the telephone company will notify you as soon as possible. Also, you
will be advised of your rights to file a complaint with the FCC if you believe it is necessary.
The telephone company may make changes to its facilities, equipment, operations, and procedures that
can affect the operation of your modem. If this happens, the telephone company provides you advance
notice for making the necessary modifications to your modem to maintain uninterrupted service.
Also, this equipment cannot be used on telephone company-provided coin service. Connection to a
party line is subject to state tariffs.
If you experience problems with this equipment, contact Raymar-Telenetics for repair and/or warranty
information. If the trouble is causing harm to the telephone network, the telephone company may
request that you remove the equipment from the network until the problem is resolved.
FCC Regulations
The Federal Communications Commission (FCC) of the U.S.A. has published regulations that govern
the allowable limits of emissions of radio frequency energy for computing devices and associated
peripherals. These regulations are concerned with interference to radio communications, such as radio
and television. The regulations require equipment for end use in the U.S.A. to be labeled and to be
accompanied by the warning which appears on the Notice page at the beginning of this manual.
There is no guarantee, however, that interference will not occur in a particular installation. If it does,
you may be required, at your own expense, to take whatever measures are necessary to correct the
situation.