Page 46/50
I SBG-Disc CAN-EN-Rev. A
SBGuidance Disc I Rev. A I CAN
4.8.
Set the stone protection
The accumulator of the stone protection should
be filled to a certain level of hydraulic pressure
to ensure that the disk is able to penetrate the
soil, but also will be able to move upward in
case a rock is hit.
Use an external spool valve to set a low pre
charge of 50 bar. Determine if this is enough,
by checking if the disk stays in the soil while
working. If it is set too low, raise the pre charge
with 10 bar at a time.
A value between 50 and 100 bar should be
sufficient for all applications.
4.9.
Checking the centre
The centre position of the disc control is
important in order to ensure the correct
successive follow-up of work operations. If the
DynamIQ is calibrated and the GPS antenna is
positioned in the centre of the implement,
generally only a few centimetres need to be
corrected.
Follow the steps described below:
1.
First check the centre of the tractor. Does
the tractor drive back and forth in the
same track?
2.
The stabilization of the tractors hitch
must be loose.
Summary of Contents for SBGuidance Disc
Page 2: ...Page 2 50 I SBG Disc CAN EN Rev A SBGuidance Disc I Rev A I CAN Intentionally left blank ...
Page 8: ...Page 8 50 I SBG Disc CAN EN Rev A SBGuidance Disc I Rev A I CAN Intentionally left blank ...
Page 36: ...Page 36 50 I SBG Disc CAN EN Rev A SBGuidance Disc I Rev A I CAN Intentionally left blank ...
Page 48: ...Page 48 50 I SBG Disc CAN EN Rev A SBGuidance Disc I Rev A I CAN Intentionally left blank ...