Commissioning
6
42
6.6.3
Both coupling versions
For the mechanical drive of the fertiliser spreader only:
7.
Mount the drive shaft to the tractor.
With the first commissioning, adjust the universal drive shaft to the tractor.
8.
Shorten the universal drive shaft, if required.
NOTICE
Observe the installation and shortening instructions provided in the
operator’s
manual of the drive shaft manufacturer
when checking and adjusting the drive
shaft. The operator’s manual is attached to the drive shaft on delivery.
n
CAUTION
Material damage due to excessive length of drive shaft
When connecting the machine the universal drive shaft halves can
come into contact inside each other. This can cause damage to the
drive shaft, the gearbox or the machine.
Check the clearance between the machine and the tractor.
Make sure there is enough space (at least 20 to 30mm)
between the outer pipe of the drive shaft and the protective
cone on the spreading side.
NOTICE
Only
your dealer or your specialist workshop may shorten the universal drive
shaft.
Summary of Contents for TWS 85.1
