Spreading operation
B
104
AXIS
A
X
IS
20.
2
B.5.3
Adjusting the drop point
With the selection of the spreading disc type, you can specify a particular range
for the working width. By altering the drop point, the working width can be accu-
rately set and adjustments to different fertiliser types can be made.
You can set the drop point via the upper scale arc.
Adjusting in the direction of smaller numbers:
The fertiliser is ejected
sooner. This results in spreading patterns for smaller working widths.
Adjusting in the direction of larger numbers:
The fertiliser is ejected later
and spread more towards the outside into the overlap zones. This results in
spreading patterns for larger working widths.
Figure 13:
Adjustment centre for drop point
1.
Determine the position for the drop point in the fertiliser chart or by carrying
out a test using the practice test kit (optional equipment).
2.
Grip the left and right handle.
3.
Press the pointer unit.
The lock is released. The adjustment centre can be moved.
4.
Move the adjustment centre with the pointer to the calculated position.
5.
Release the pointer unit.
The adjustment centre is locked.
6.
Ensure that the adjustment centre is locked.
K
D
R
C
Q
W
EMC
Summary of Contents for AXIS-M 20.2 EMC
