Raritan Paragon II, Deployment Manual

Page: 16 / 64

8 P
ARAGON
II / C
OMMAND
C
ENTER
I
NTEGRATION
S
OLUTIONS
D
EPLOYMENT
G
UIDE
Updating UST-IP and IP-Reach Devices
CommandCenter Secure Gateway can also update any UST-IP or IP-Reach devices in your PCCI
configuration. Note that as part of a PCCI setup, the associated P2SC is still selected from the
Device tree, not the UST-IP or IP-Reach devices themselves.
Exception: If CommandCenter Secure Gateway directly manages the IP-Reach devices, you can
select the IP-Reach devices themselves from the Device tree.
1. Click on the Devices tab and select the associated P2SC device from the Devices tree.
2. On the Devices menu, click Device Manager , and then click Remote User Station Admin .
3. CC-SG will display a list of IP-Reach and UST-IP units managed by P2SC. Make sure that
all IP-Reach and UST-IP units are listed before proceeding. If any are missing, wait a short
while then check again.
4. On the Devices menu, click Device Manager , and then click Upgrade Device . The Upgrade
Device screen appears.
5. Click on the Firmware Name drop-down arrow and select the appropriate firmware from the
list for your UST-IP or IP-Reach.
6. Click OK to upgrade the device or Cancel to close the Upgrade Device screen.
7. If the firmware version of the device is not compatible with CC-SG, a message will alert you
and ask if you want to proceed. Click
Yes to upgrade the device, or No to cancel the
operation.
8. A Restart message appears; click Yes to restart the device or No to close the window without
restarting.
9. A Device Upgraded Successfully message confirms that all devices of that type have been
upgraded.
Note: The P2SC device will reboot along with the UST-IP or IP-Reach devices once the firmware
upgrade is complete. Again, the P2SC will take several minutes to rediscover and catalog
assigned Paragon II configurations. Larger configurations will take longer rediscover, please
wait several minutes before trying to access the P2SC again.
This will upgrade all UST-IP or IP-Reach devices (depending on which firmware) at once. If you
use a mixture of UST-IP or IP-Reach units, repeat steps 1 through 6 to upgrade the other set of
devices.