Rapid Engineering CGTH-30, Installation & Operation Manual

Page: 31 / 64

SECTION 8 : I
NSTALLATION
25 of 55
8 .13 Grille Installation (for Select Models Only)
A protecti v e grille is incl u ded w ith select models of
the CGTH-Series heater. This grille is s u pplied in
sections and m u st b e installed on the u nderside of
the reflector prior to operation.
Grille sections are held in position b y a channel
formed b y the rolled edge of the reflector. The shorter
length heater 8' (2.4 m) req u ires installation of t w o
protecti v e grille sections, w hile the longer heater 11'
6" (3.5 m) req u ires three protecti v e grille sections.
Grille Section (P/N 08050001) is open-ended and
installed along the length of the reflector. Grille End
Cap (P/N 08050002) is the formed end cap and is
installed at the end of the grille that is f
u rthest from
the bu rner.
Installation:
Step 1. Silicone Cap Installation. See Page 25, Fig-
ure 15 .
• Silicone caps (P/N 91915951) are to b e placed
along each side of the grille at b oth end fingers
and the center finger.
FIGURE 15: Silicone Cap Installation
Step 2. Attach grille end cap to final grille section.
See Page 25, Figure 16 .
Step 3. Install grille sections as follo w s on Page 26,
Figure 17 .
• Attach first grille section(s) (P/N 08050001) to
u nderside of reflector as sho w n. The w ires of the
grille w ill rest in the channel formed b y the rolled
edges of the reflector. Be certain the silicone caps
ha v e b een installed.
• Attach final grille section w ith end cap to u nder side
of reflector. B u tt grille to w ard the front fixed hanger
that is adjacent to the bu rner and to each other as
sho w n.
FIGURE 16: Grille End Cap Installation
Silicone Cap
P/N 91915951
Grille
Finger
Silicone Caps are s u pplied
for the ends of the grille.
Bend u p 9 0°
3
P u ll o ut ward
4
S I D E V IE W
2
Grille
Grille End Cap
1