Ranger Products RX3040, Installation And Operation Manual

Page: 55 / 74

55
7. The Limit switch is located under the Tool Head
Sliding Arm.
8. Loosen the Socket Head Cap screws and move the
switch assembly forward or rearward as required.
(See Fig. 17.6)
9. Tighten The Socket Head Cap Screws. (See Fig. 17.7)
10. Power up the Machine and press and hold the One
Touch Button until the Tool Head Arm stops extending.
11. Lower the Tool Head to gauge the distance from the
Tab Side of the Tool Head to the Lower Rim Edge.
(See Fig. 17.8)
12. Raise the tool head above the Rim and repeat
adjustment procedure if necessary until the desired
distance is obtained.
NOTE:
THE TOOL HEAD IS ADJUSTED FROM THE
FACTORY SO THAT THE TAB SIDE OF THE TOOL
HEAD WILL BE 1/8” FROM THE RIM EDGE WHEN
PUSHING AND HOLDING THE Target Lock™
BUTTON ON THE TOOL HEAD JOYSTICK
CONTROL. THE HOOK SIDE WILL BE SLIGHTLY
FARTHER AWAY FROM THE RIM EDGE.
Fig. 17.6
Fig. 17.7
Fig. 17.8