Ranger Products RX3040, Installation And Operation Manual

Page: 27 / 74

27
3. The Oil Reservoir is filled by unscrewing the OIl Fill
Cap. The Oil Level should remain in the Upper Sight
Glass when Full. (See Fig. 9.38)
4. The Oiler is adjusted by turning the Small Screw
located on top of the Oil View Glass. (See Fig. 9.39)
5. Adjust the oil flow so that two to three drops are
visible through the Oil Flow Site Glass when operating the
Wheel Lift.
Water Reservoir
2. To Drain the Water Reservoir Unscrew the Drain plug
1/4 turn and then push up till all water is removed from
water Reservoir. (See Fig. 9.40)
3. When complete, close the drain 1/4 turn.
CAUTION!
THE AIR SUPPLY MUST BE DISCONNECTED PRIOR
TO FILLING THE OIL RESERVOIR.
NOTE!
THE AIR SUPPLY SHOULD BE CONNECTED WHEN
DRAINING THE WATER RESERVOIR.
Fig. 9.38
Fig. 9.40
Fig. 9.39