R&S SMW-K555, User Manual

Page: 35 / 45

Bandwidth Extension settings
R&S
®
SMW-K555
35 User Manual 1179.5776.02 ─ 01
└ Scan Analyzers ............................................................................................... 35
└ Instrument ....................................................................................................... 35
└ Hostname or IP Address .................................................................................36
Use Coupler .................................................................................................................. 36
Measurement Device
Selects the measurement device. This device is the source instrument for RF ports
alignment.
You can select an R&S NRP sensor or a vector signal analyzer.
"None" No source instrument for RF ports alignment.
Use this setting, if you run a separate alignment of the LO phases of
the RF output signals.
"NRP Sensor" Selects an R&S NRP sensor for alignment. For sensor settings, see
"Sensor settings" on page 35.
"Analyzer" Selects a vector signal analyzer for synchronization. For analyzer set-
tings, see
"Analyzer settings" on page 35.
Remote command:
n.a.
Sensor settings
Sensor settings require "Measurement Device" > "NRP Sensor".
Sensor ID ← Sensor settings
Sets the ID number of the used R&S NRP sensor.
Remote command:
n.a.
Sensor Name ← Sensor settings
Displays the name of the used R&S NRP sensor.
Remote command:
n.a.
Analyzer settings
Analyzer settings require "Measurement Device" > "Analyzer".
Scan Analyzers ← Analyzer settings
Scans the network for connected, supported vector signal analyzers.
Remote command:
n.a.
Instrument ← Analyzer settings
Select an instrument from a list as a result from "Scan Analyzers".
To add instruments manually, select "Instrument" > "New" and set their hostname or IP
address.
Remote command:
n.a.
Setup file editor settings