R&S SMW-K555, User Manual

Page: 19 / 45

Extending the bandwidth
R&S
®
SMW-K555
19 User Manual 1179.5776.02 ─ 01
6 5 4
2 1 3
1 = Bandwidth extension state
2 = Bandwidth extension setup file
3 = Alignment info, alignment status and access to setup alignment wizard
4 = Device under test (DUT)
5 = Power combiner
6 = Signal generator block
To manage bandwidth extension setup files
The following procedure describes how to create, edit and save a bandwidth extension
setup file.
1. Open the bandwidth extension setup file-select dialog.
See steps (1) and (2) in "To load a bandwidth extension setup" on page 17.
2. To create a bandwidth extension setup file, proceed as follows:
a) Select "New".
b) Enter the filename.
c) Select "Ok".
The file is created using the default configuration: Single R&S SMW using both
ports and one power combiner.
3. To edit a bandwidth extension setup file, proceed as follows:
a) Select the file.
b) Select "Edit"
The "Bandwidth Extension Setup File Editor" dialog opens with settings to config-
ure RF ports and align the setup. See
Chapter 4.2, "Setup file editor settings" ,
on page 31.
Configuring the R&S SMW