Extending the bandwidth
R&S
®
SMW-K555
20
User Manual 1179.5776.02 ─ 01
4. Optionally, configure RF ports.
"To monitor the RF ports settings of a single R&S
5. Optionally, configure settings for setup alignment.
"To align RF ports with a power sensor"
To align the setup with a signal analyzer
This procedure describes how to execute an alignment of your bandwidth extension
setup. Typically, align the setup once assuming that you do not change the cabling or
connected devices in your setup.
The signal analyzer is switched-on and connected to the R&S
SMW via LAN, see
on page 17. For prerequisites of the signal analyzer, see
1. Load a bandwidth extension setup file.
"To load a bandwidth extension setup"
2. In the general settings of the "Bandwidth Extension" side-tab, execute the follow-
ing:
a) Activate bandwidth extension ("State" > "On").
When aligning for the first time, the setup is not aligned. An exclamation mark
displays a non-aligned setup on the "Info / Align" button.
b) Select "Info / Align".
The "Setup Info / Align" dialog opens and displays a non-configured alignment.
3. Select "Align Setup".
The "Align Setup Wizard" dialog opens and guides you through the steps to config-
ure the measurement device, to align power levels and cable lengths.
The measurement device is a signal analyzer.
4. In the "Instrument" list, select you signal analyzer.
If not listed, scan your network to add your signal analyzer.
5. If detected, select the signal analyzer in the "Instrument" selection.
Configuring the R&S
SMW
